Hi all My bike will not start it turns over but not firing, so i connected tuneecu to it but it will not connecting the red light at the bottom right flashes and the light on the lead lights the, computer knows the lead is connected (device manager). I have formated the computer and reloaded tuneecu and the drivers which loaded ok any ideas.
Thanks Dave
Advertisement Remove adverts by upgrading to a premier account
1:Duff cable (especially if a £10 one off fleabay.
2: OK, a bit more info is needed. Are all idiot lights on including neutral and MiL ?
3: Its often worth swapping the main power relay in this scenario just in case its a simple relay fault (this relay powers up the circuit needed for tuneecu to connect; you should have 12v on pin 16 (orange) of the diagnostic connector)
I have used the cable before but i will check the four wires are connected, Yes the idiot light are on, the light on the cable is lit but i will check for 12v
